In
https://forums.opensuse.org/showthre...-BCM4352/page4
(which I shouldn't have used, since the problem is not with Tumbleweed, as as this thread, but with Leap 15.1),
I was advised to install broadcom-wl and broadcom-wl-kmp-default packages to get the ASUS PCE-AC56 wordking with Leap 15.1.
A good advice, because now the card is seen, and the hardware sees the wifi-networks available in the environment.
But when I enter the credentials for the wifi-point I want to use (the wifi-point as such is detected correctly), it is some seconds apparently trying to connect to the access point, but then keeps asking for the WPA2 passwd. The passwd is correct, our mobile phones connect to the same access point with the same password, and I checked it in the router settings.
The network is managed by Networkmanager. The settings for this wifi-connection gives all users access to the network, and the WPA2-key is given there too.
hwinfo --netcard says
Modprobe bcma doesn't change anything, and is revoked on reboot.
ip address says
and in journalctl these messages show after trying to connect:
Any one with an idea how I can establish the connection? Preferable without having to enter the root passwd...
Many thanks in advance!
https://forums.opensuse.org/showthre...-BCM4352/page4
(which I shouldn't have used, since the problem is not with Tumbleweed, as as this thread, but with Leap 15.1),
I was advised to install broadcom-wl and broadcom-wl-kmp-default packages to get the ASUS PCE-AC56 wordking with Leap 15.1.
A good advice, because now the card is seen, and the hardware sees the wifi-networks available in the environment.
But when I enter the credentials for the wifi-point I want to use (the wifi-point as such is detected correctly), it is some seconds apparently trying to connect to the access point, but then keeps asking for the WPA2 passwd. The passwd is correct, our mobile phones connect to the same access point with the same password, and I checked it in the router settings.
The network is managed by Networkmanager. The settings for this wifi-connection gives all users access to the network, and the WPA2-key is given there too.
hwinfo --netcard says
Code:
18: PCI 300.0: 0282 WLAN controller
[Created at pci.386]
Unique ID: y9sn.fkUtWxV49cB
Parent ID: gZD2.Gxy18Qr5+gA
SysFS ID: /devices/pci0000:00/0000:00:0b.0/0000:03:00.0
SysFS BusID: 0000:03:00.0
Hardware Class: network
Model: "Broadcom BCM4352 802.11ac Wireless Network Adapter"
Vendor: pci 0x14e4 "Broadcom"
Device: pci 0x43b1 "BCM4352 802.11ac Wireless Network Adapter"
SubVendor: pci 0x1043 "ASUSTeK Computer Inc."
SubDevice: pci 0x85ba
Revision: 0x03
Driver: "wl"
Driver Modules: "wl"
Device File: wlan0
Features: WLAN
Memory Range: 0xdfff8000-0xdfffffff (rw,non-prefetchable)
Memory Range: 0xdfc00000-0xdfdfffff (rw,non-prefetchable)
IRQ: 19 (30359 events)
HW Address: a2:5f:9c:c2:7b:4d
Permanent HW Address: 04:d9:f5:7a:cb:d0
Link detected: yes
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 36 38 40 42 44 46 48 52 54 56 58 60 62 64 100 102 104 106
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 2.484 5.18 5.19 5.2 5.21 5.22 5.23 5.24 5.26 5.27 5.28 5.29 5.3 5.31 5.32 5.5 5.51 5.52 5.53
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v000014E4d000043B1sv00001043sd000085BAbc02sc80i00"
Driver Info #0:
Driver Status: bcma is not active
Driver Activation Cmd: "modprobe bcma"
Driver Info #1:
Driver Status: wl is active
Driver Activation Cmd: "modprobe wl"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #13 (PCI bridge)ip address says
Code:
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state DORMANT group default qlen 1000
link/ether aa:e8:50:f5:4f:ee brd ff:ff:ff:ff:ff:ffCode:
mrt 15 17:08:30 linux-vffq kernel: WARNING: CPU: 0 PID: 545 at ../net/wireless/sme.c:948 cfg80211_roamed+0x23e/0x270 [cfg80211]
mrt 15 17:08:30 linux-vffq kernel: Modules linked in: fuse xt_tcpudp ip6t_rpfilter ip6t_REJECT ipt_REJECT xt_conntrack ip_set nfnetlink ebtable_nat ebtable_broute br_netfilter bridge stp llc af_packet ip6table_nat nf_conntra>
mrt 15 17:08:30 linux-vffq kernel: soundcore btrfs xor zstd_decompress zstd_compress xxhash raid6_pq sr_mod cdrom hid_generic usbhid ata_generic nouveau video mxm_wmi wmi i2c_algo_bit drm_kms_helper syscopyarea sysfillrect >
mrt 15 17:08:30 linux-vffq kernel: CPU: 0 PID: 545 Comm: wl_event_handle Tainted: P W O 4.12.14-lp151.28.36-default #1 openSUSE Leap 15.1
mrt 15 17:08:30 linux-vffq kernel: Hardware name: System manufacturer System Product Name/M2N68-AM Plus, BIOS 1804 08/23/2010
mrt 15 17:08:30 linux-vffq kernel: task: ffff8801376ea200 task.stack: ffffc90000b3c000
mrt 15 17:08:30 linux-vffq kernel: RIP: 0010:cfg80211_roamed+0x23e/0x270 [cfg80211]
mrt 15 17:08:30 linux-vffq kernel: RSP: 0018:ffffc90000b3fde8 EFLAGS: 00010246
mrt 15 17:08:30 linux-vffq kernel: RAX: 0000000000000000 RBX: ffffc90000b3fe20 RCX: 0000000000000012
mrt 15 17:08:30 linux-vffq kernel: RDX: 0000000000000002 RSI: 00000000fffffe01 RDI: ffffffffa06d0bf7
mrt 15 17:08:30 linux-vffq kernel: RBP: ffffc90000b3fe10 R08: 0000000000000000 R09: 0000000000000000
mrt 15 17:08:30 linux-vffq kernel: R10: ffffc90000b3fd50 R11: 0000000000000064 R12: 00000000014000c0
mrt 15 17:08:30 linux-vffq kernel: R13: ffff880139d4d000 R14: ffff880137054300 R15: dead000000000100
mrt 15 17:08:30 linux-vffq kernel: FS: 0000000000000000(0000) GS:ffff88013fc00000(0000) knlGS:0000000000000000
mrt 15 17:08:30 linux-vffq kernel: CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
mrt 15 17:08:30 linux-vffq kernel: CR2: 00007fd706b374c4 CR3: 000000008546c000 CR4: 00000000000006f0
mrt 15 17:08:30 linux-vffq kernel: Call Trace:
mrt 15 17:08:30 linux-vffq kernel: wl_bss_roaming_done.isra.26+0xb5/0x100 [wl]
mrt 15 17:08:30 linux-vffq kernel: wl_notify_roaming_status+0x30/0x70 [wl]
mrt 15 17:08:30 linux-vffq kernel: ? down_interruptible+0x2d/0x50
mrt 15 17:08:30 linux-vffq kernel: wl_event_handler+0x73/0x1e0 [wl]
mrt 15 17:08:30 linux-vffq kernel: ? wl_notify_scan_status+0x300/0x300 [wl]
mrt 15 17:08:30 linux-vffq kernel: kthread+0x10d/0x130
mrt 15 17:08:30 linux-vffq kernel: ? kthread_create_worker_on_cpu+0x50/0x50
mrt 15 17:08:30 linux-vffq kernel: ret_from_fork+0x22/0x40
mrt 15 17:08:30 linux-vffq kernel: Code: 8d 4d 70 45 0f b6 85 90 00 00 00 45 8b 8d a8 00 00 00 4c 89 f7 48 8b 36 e8 10 a4 fd ff 48 85 c0 48 89 43 08 5a 0f 85 f9 fd ff ff <0f> 0b 48 8d 65 d8 5b 41 5c 41 5d 41 5e 41 5f 5d c3 4>
mrt 15 17:08:30 linux-vffq kernel: ---[ end trace 63e68e12822c9ad6 ]---Many thanks in advance!