Installed openSUSE Factory using the openSUSE-Factory-NET-i586-Current.iso.
During installation, wireless is detected but unable to connect so the installation was performed with Ethernet (RJ45) cable instead of wireless.
After installation,
noticed that when using Ethernet (RJ45) cable, do not need to wait much for the internet connection to be established during boot up.
However, if I were to remove the Ethernet cable and try to connect using wireless during boot up, will need to wait approximately 2 minutes before openSUSE activates the wireless connection.
Not wanting to wait for the 2 minutes for wireless to connect,
wanted to configure wireless in Yast but the option is masked out as shown below.
![]()
Any advise how I can configure the wireless properly?
During installation, wireless is detected but unable to connect so the installation was performed with Ethernet (RJ45) cable instead of wireless.
After installation,
noticed that when using Ethernet (RJ45) cable, do not need to wait much for the internet connection to be established during boot up.
However, if I were to remove the Ethernet cable and try to connect using wireless during boot up, will need to wait approximately 2 minutes before openSUSE activates the wireless connection.
Not wanting to wait for the 2 minutes for wireless to connect,
wanted to configure wireless in Yast but the option is masked out as shown below.
Any advise how I can configure the wireless properly?