I get those errors trying to boot openSUSE. They show up after it tries to load the linux 3.11.6-4 desktop and the initial ramdisk respectively.
My problem is long, and the issues before this are all listed http://redd.it/2gtgxf there. I haven't updated it since my last install attempt. Basically all the same, but I put the 200MB boot partition set as bios grub (iirc, may have been efi boot) and mounted it on /boot/efi. The installer had me install grub2-efi, and I'm pretty sure I checked support secure boot.
I ran both fdisk -l and parted -l on my /dev/sda, and the results are:
fdisk -l:
parted -l:
Now I can FINALLY boot my HDD after all this trouble. I'm so close I can almost taste it. But I'm getting this error when booting into openSUSE:
My problem is long, and the issues before this are all listed http://redd.it/2gtgxf there. I haven't updated it since my last install attempt. Basically all the same, but I put the 200MB boot partition set as bios grub (iirc, may have been efi boot) and mounted it on /boot/efi. The installer had me install grub2-efi, and I'm pretty sure I checked support secure boot.
I ran both fdisk -l and parted -l on my /dev/sda, and the results are:
fdisk -l:
Code:
Disk /dev/sda: 2000.4 GB, 2000398934016 bytes, 3907029168 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disk label type: gpt
# Start End Size Type Name
1 2048 401407 195M BIOS boot parti primary
2 401408 33961983 16G Microsoft basic primary
3 33961984 453386239 200G Microsoft basic primary
4 453386240 3907028991 1.6T Microsoft basic primaryCode:
Model: ATA ST2000DM001-9YN1 (scsi)
Disk /dev/sda: 2000GB
Sector size (logical/physical): 512B/4096B
Partition Table: gpt_sync_mbr
Number Start End Size File system Name Flags
1 1049kB 206MB 204MB fat16 primary bios_grub, legacy_boot
2 206MB 17.4GB 17.2GB linux-swap(v1) primary
3 17.4GB 232GB 215GB ext4 primary
4 232GB 2000GB 1768GB ext4 primaryCode:
Loading Linux 3.11.6-4-desktop ...
error: can't find command 'linuxefi'.
Loading initial ramdisk ...
error: can't find command 'initrdefi'.